Home > News > Content
The Installation Method Of The Torque - Limited Hydraulic Coupler
Apr 08, 2018

Most limited moment type hydraulic coupler body made of aluminum alloy, due to the low strength of aluminum alloy, with hammers so will make it out of shape, craze after coupling shell, oil leakage, therefore, coupling directly with hammer percussion shell is forbidden when installation, applying force or pressure in the shell with press, suggest installation in the following way;

1. Use the tightening bolt tool installation method.

A. Drill A screw hole on the motor shaft or reducer shaft.

B. Hoist the coupling to the motor shaft or reducer shaft.

C. install flange in the rear end of the main shaft of the coupling.

D. Rotate the installation tool to pull the coupling to the motor shaft.

E. tighten bolts to tighten the coupling and motor shaft or reducer shaft.


2. Add pad hammer to install method on the back end of main shaft.

A. Install flange on the rear end of the main shaft of the coupling. Note: the flange must be mounted, and the main shaft of the coupling can not be hit directly with the hammer, so as to prevent the sealing of the main shaft or remove the screw hole.

B. The copper bar is used to hit the main shaft of the coupling with a hammer, and slowly the coupling is installed on the motor shaft or the reducer shaft.